aldly
plate_pusher_delay
ppd
Trendsetter_400/800_Auto
The unload table plate pusher is a device that can be used to push a plate against the
unload table to help the cups grab the plate. This plate_pusher_delay value specifies
the time to wait between retracting the plate pusher and moving the plate further up
the unload table during an UNLOAD. There is no sensor to indicate when the plate pusher
has retracted, so this delay ensures that the actuator is retracted and that the plate
can be moved without it being damaged.
uint32
0
0 to 60 [seconds]
Setting the delay to zero will disable the plate pusher completely.
The plate pusher will only be activated if needed - i.e., if the cups on the unload table
cannot grab the plate on the first try.
Only supported in firmware versions 1.10 and above.
cal